Smithy Ez-Trol2 Manual do Utilizador descarregar pdf (Página 46)

The add and subtract radio buttons, denoted by item 3E, tell EZ-Trol to “Add” or “Subtract” the tool

adius or length to/from the part zero position.

4 ZERO ALL

licking on the Zero All button will zero the current values in the X, Y, Z and A axis values for the

selected offset. It will not zero all offsets, only the offset that is currently selected.

SETTING-UP A PROJECT

Regardless of the method you use to create G-code, you will need to set your project up in EZ-TROL.

An overview is given below of this process.

1 Secure the work piece to the table.

2 Left Click on the manual tab. Left click on the Axis Set-up button and click on the “All

Home” button. Remember if this is the first time homing the machine, Smithy suggest

homing one axis at a time to become familiar with the feed rate and distance of travel.

3 Using a wiggler or some other sort of edge finding device, determine the edges of your

work piece by jogging each axis in place until you have found the edge. Remember to

compensate for the tool radius.

4 When the work piece edges have been located, the machine tool needs to learn this

position to each axis. This action is completed in the Setting Tab. (See Chapter 8 for

more details.)

5 Once the cutter is located at part zero, select an offset that is not being used. T

each

each axis its current location by clicking the “T

each” button after the field displaying

the axis’s position.

w SmithyCNC EZ-Trol II Control System

40 | Toll Free 1-800-476-4849

Figure 11.2 Settings Offsets Screen

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 82 83

Sem comentários

Smithy Ez-Trol2 Manual do Utilizador Página 46